1 , the total cross-sectional area should be greater than the export of sectional area fan 1/2.
2, as in the water send spirit, the depth of water pressure on model should be marked in the catalogue of the maximum static pressure value below 70%.
3, to send spirit pressure, the temperature of the air friction for export relationship than normal temperature 10 degrees Celsius is a normal, reason should be more than 1 M use iron pipe.

B, the suction with-the exit can add muffler
    The total sectional area inhaled hole should be greater than blower entrance of sectional area 1/2.

C, filter simple cleaning method:
    Will filter rotation joint swings open with air gun or brush will mesh of dirt or dust removal, after cleaning the spinning back can use.

The installation ofhigh-pressure blower

A, installation place
  Surrounding temperature and humidity, shall meet the following conditions:
  1 and single phase-5 ~ 40 ℃ three-phase-10 ~ 40 ℃
  2, choose well ventilated, dust and moisture little place.
  3, installation in the open air person, please use rain hood.

B, installation method
    High pressure air blower can be in any Angle installation, use screws really is fixed to the level and provide the basis or base hardness.Basic weight is about 3 times of the high-pressure blower standard.Should pay special attention to base is rugged, if it is, when tightening bolts, high-pressure blower a possible deformation!!!!!Shock can be mounted to reduce noise.The suction on not connect ventilation, to prevent dangerous or foreign body inhaled, please add barbed wire or filter.